Removing A Tape Drive Or Other Device From A Removable Media Bay - Compaq 234664-002 - ProLiant - ML330T02 Setup And Installation Manual
Compaq proliant ml330e/ml330 server setup and installation guide
Hide thumbs
Also See for 234664-002 - ProLiant - ML330T02:
- Troubleshooting manual (188 pages) ,
- Setup and installation manual (160 pages) ,
- Maintenance and service manual (93 pages)
Table of Contents
Advertisement
3-18 Compaq ProLiant ML330e/ML330 Server Setup and Installation Guide
Removing a Tape Drive or Other Device from a
Removable Media Bay
IMPORTANT: The following section applies only to the ProLiant ML330 server or ProLiant
ML330e server models with a SCSI option card.
To remove a tape drive or other device:
CAUTION: To prevent damage to equipment or loss of information, make sure
that the server is powered down, all cables are disconnected from the back of
the server, and the power cord is disconnected from the grounded (earthed) AC
outlet before removing the access panel.
1. Follow the steps in "Removing the Access Panel" at the beginning of
this chapter.
2. Disconnect the power and data cables from the back of the device.
Figure 3-18. Disconnecting the SCSI cable
Advertisement
Chapters
Table of Contents
