Table of Contents
Advertisement
S
U
ETTING
DISH P
LAYER
Use these special instructions only if you are going to use the green 1
UHF Pro key to control the TV1 side of your DISH Player-DVR 522 or
625.
When you are finished setting up the remote control, you'll be able to
operate the TV1 side of your DISH Player-DVR 522 or 625 from long
distances.
1
Make sure the key is installed as described on pages
C-1 and C-2.
2
Make sure the UHF Antenna is attached to the back
of the receiver.
3
Using the receiver's front panel buttons, press MENU. Select the
following onscreen items in this sequence:
a. System Setup.
b. Installation.
c. TV1 UHF Pro Setup.
4
Select Enable from the TV1 UHF Pro Setup screen.
5
Select System Info to open the System Information screen.
6
Use the ARROW buttons to move the highlight to the address for
Remote Address as shown below. This is important - if
the
you do not move the highlight, your remote will change the
receiver's
11
TV1 UHF P
P A
-DVR 522
Remote Address and cause your Remote Control
R
RO
EMOTE FOR THE
625 O
AND
NLY
Hide quick links:
Advertisement
Table of Contents
