Advertisement
Quick Links
AUTO CHARGE D
PUMP PLUS
AUTOMATIC DUAL OUTPUT BATTERY CHARGER
WITH AIR BRAKE LEAKAGE COMPENSATOR
Designed expressly for vehicles with DDEC ENGINES
INPUT :120 volt, 50/60 Hz, 8 amps
OUTPUT VEHICLE BATTERY: 25 AMPERES
OUTPUT ENGINE BATTERY: 3 AMPERES
OUTPUT BATTERY SAVER : 5 AMPERES
1 YEAR WARRANTY ON AIR COMPRESSOR
3 YEAR WARRANTY ON CHARGER
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
INSTRUCTION MANUAL
MODEL #091-9-DPP
TOLL FREE: 800-346-0857
BOOK# 091-66
file:091-9-dpp
4-15-02
.
FAX: 631-567-5826
Advertisement
Related Manuals for KUSSMAUL 091-9-DPP
Summary of Contents for KUSSMAUL 091-9-DPP
- Page 1 OUTPUT ENGINE BATTERY: 3 AMPERES OUTPUT BATTERY SAVER : 5 AMPERES 1 YEAR WARRANTY ON AIR COMPRESSOR 3 YEAR WARRANTY ON CHARGER KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857...
- Page 2 INTRODUCTION The Auto Charge D-PUMP PLUS is a dual battery system automatic bat- tery charger designed specifically for vehicles with a DDEC control and a sepa- rate engine battery. The engine battery on DDEC equipped vehicles presents a unique prob- lem.
- Page 3 AUTOMATIC CURRENT LIMITING The charger contains automatic current limiting for each output. The vehicle output is limited at 25 amperes while the engine output is limited at 3 amperes. This provides the higher current to the larger batteries where it is needed. BATTERY SAVER &...
-
Page 4: Installation Wiring Diagram
INSTALLATION WIRING DIAGRAM IMPORTANT : Wire size is WIRE SIZE CHART for a maximum length of 10 CONNECTION DEFINITION WIRE SIZE feet. If wiring is to be longer, NEGATIVE CHARGING LEAD 8 AWG larger wiring is required. POSITIVE CHARGING LEAD ENGINE BATTERY 14 AWG ENGINE BATTERY Additional information is... -
Page 5: Indicator Installation
INDICATOR INSTALLATION 1. Locate Indicator in a convenient place on the vehicle. 2. Place the template in position and center punch in 4 places. 3. Drill holes as shown. 5. Cut out square hole. 6. Connect wiring to charger using butt connector supplied. 7. -
Page 6: Specifications
SPECIFICATIONS: Input: 120 volt, 50/60 Hz, 8 amperes Input Fuse: 12 amperes, Fast Blow Output - Vehicle: 25 amperes Max. Output - Engine: 3 amperes Max. Output - Battery Saver: 5 amperes Max. Indicators: Power: Red LED, indicates 120 volt power applied Battery Saver Overload: Yellow LED, flashing, indicates BAT TERY SAVER load greater than 5 amperes Dual Bar Graph: indicates charger output to two batteries and state... -
Page 7: Warranty
Vehicle Identification Vehicle Owner WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped.