Advertisement
Quick Links
BOOK# 091-66
INSTRUCTION MANUAL
AUTO CHARGE D2
AUTOMATIC TRIPLE OUTPUT
BATTERY CHARGER
Designed expressly for vehicles with DDEC ENGINES
MODEL #091-74-12
INPUT :120 volt, 50/60 Hz, 8 amps
OUTPUT VEHICLE BATTERIES: 25 AMPERES
OUTPUT ENGINE BATTERY: 3 AMPERES
OUTPUT BATTERY SAVER : 5 AMPERES
3 YEAR WARRANTY
.
KUSSMAUL ELECTRONICS CO., INC
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314
TOLL FREE: 800-346-0857
FAX: 631-567-5826
Advertisement
Related Manuals for KUSSMAUL 091-74
Summary of Contents for KUSSMAUL 091-74
-
Page 1: Battery Charger
INPUT :120 volt, 50/60 Hz, 8 amps OUTPUT VEHICLE BATTERIES: 25 AMPERES OUTPUT ENGINE BATTERY: 3 AMPERES OUTPUT BATTERY SAVER : 5 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO., INC 170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826... - Page 2 INTRODUCTION The Auto Charge D2 is a triple battery system automatic battery charger de- signed specifically for vehicles with a DDEC control and a separate engine battery. The engine battery on DDEC equipped vehicles presents a unique problem. While it is desirable to have a charger to maintain this battery in a fully charged condition, this battery is relatively lightly loaded.
- Page 3 Automatic Current Limiting The charger contains automatic current limiting for each output. The vehicle output is limited at 25 amperes while the engine output is limited at 3 amperes. This provides the higher current to the larger batteries where it is needed. BATTERY SAVER &...
-
Page 6: Indicator Installation
INDICATOR INSTALLATION 1. Locate Indicator in a convenient place on the vehicle. 2. Place the template in position and center punch in 4 places. 3. Drill holes as shown. 5. Cut out square hole. 6. Connect wiring to charger using butt connector supplied. 7. -
Page 7: Specifications
SPECIFICATIONS: Input: 120 volt, 50/60 Hz, 8 amperes Output - Bat1 & Bat2 Vehicle: 25 amperes Max. Output - Engine: 3 amperes Max. Output - Battery Saver: 5 amperes Max. Indicators: Power: Red LED, indicates 120 volt power applied Battery Saver Overload: Yellow LED, flashing, indicates BAT TERY SAVER load greater than 5 amperes Dual Bar Graph: indicates charger output to two batteries and state of charge of batteries... -
Page 8: Warranty
Vehicle Identification Vehicle Owner WARRANTY All products of Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped.