Audio Control - Kenwood KDC-7027 Instruction Manual

General features

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "AUD" is
displayed above the [2] button.
Refer to 'Notes on Multi-function Key System'
(page 9).
3
Enter Audio Control mode
Press the [2] ("AUD") button.
4
Select the Adjustment item section
Press the [NEXT] button.
Repeatedly press the button until the desired
Adjustment item is displayed above the [2] — [5]
button.
1st section
Adjustment Item Button
Bass [2]
Middle [3]
Treble [4]
Subwoofer* [5]
2nd section
Adjustment Item Button
High Pass Filter [2]
Low Pass Filter* [3]
Loudness [4]
Balance & Fader [5]
3rd section
Adjustment Item Button
Volume offset [2]
5
Select the Audio Control item for
adjustment
Press the [2] — [5] button.
Each time the [2] — [5] button is pressed the
adjustable audio items are switched among
ranges of all stage section's tables on the
following pages.
6
Adjust the Audio Control item
Press the [ ] or [
Each time the button is pressed the setting
switches as shown below.
12
|
English
Display
"BASS"
"MID"
"TRE"
"SW"
Display
"HPF"
"LPF"
"LOUD"
"BL/F"
Display
"VOFF"
] button.
• The Adjustment item can also be controlled by the
rotary volume knob. Refer to 'Rotary Volume knob
operation mode select'(page 13).
7
Exit Audio Control mode
Press the [6] button.
• The loudness setting can also be adjusted by pressing
the [4] button.
• * This mode is available only when 'Subwoofer Output'
(page 15) is ON.
1st section
[2] button
Adjustment Item Display
Bass Center Frequency "Bass F"
Bass level "Bass"
Bass Q Factor "Bass Q"
Bass Extend "Bass EXT"
[3] button
Adjustment Item Display
Middle Center Frequency "MID F"
Middle level "Middle"
Middle Q Factor "Middle Q"
[4] button
Adjustment Item Display
Treble Center Frequency "TRE F"
Treble level "Treble"
[5] button
Adjustment Item Display
Subwoofer level "SW Level"
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the bass extend is set to ON, low frequency
response is extended by 20%.
Range
60/70/80/100 or 150 Hz
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
Range
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
Range
10.0/12.5/15.0/17.5 kHz
–8 — +8
Range
–15 — +15