Maytag MCD2257KES - 21.6 cu. Ft Use And Care Manual page 6

Installation
• Determine which
door needs to be
raised.
Turn front roller
adjustment screw
(A) clockwise to
raise front corner of
door.
If one refrigerator door has reached the limit of
its adjustment range and doors are still not level,
raise or lower the opposite door by turning roller
adjustment screw clockwise or counterclockwise.
Check with level to verify '/4"tilt to the back for
proper door closure.
If refrigerator is aligned and stable, replace toe
grille.
Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
Connecting the Water Supply
(select models)
Materials Needed:
• '/4" outer diameter flexible copper tubing
• Shut-off valve (requires a '/4" hole to be drilled into
water supply line before valve attachment)
• Adjustable wrench (2)
• '/;' hex nut driver
Notes:
• Use copper tubing only for installation. Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of service loop.
.
Create service loop with
copper tubing (minimum 2'
diameter). Avoid kinks in the
copper tubing when
bending the service loop. Do
not use plastic tubing.
2' diameter
minimum
2. Remove plastic cap from water valve
inlet port.