Slide Range Into Opening; Final Check Of Anti-Tip Bracket - GE JGSP48BHBB Installation Instructions Manual

INSTALL THE RANGE

SLIDE RANGE INTO OPENING

13
A Position the range in front of the cabinet
opening.
Make sure that the glass which overhangs
B
the countertop clears the countertop.
If necessary, raise the unit by lowering
the leveling legs.
Push while lifting the range into the
C
opening, until the range is within 2"
of engaging the anti-tip bracket.
D Remove the protective trim from the side
of glass (if provided).
Using the adjustable pliers or wrench,
E
carefully screw in the back leveling leg
until the glass overhang comes to rest
on the countertop.
Adjustable
wrench or pliers
F Carefully screw in the front two leveling
legs (similar to Step E) until the glass
overhang touches the countertop.
Carefully push the range into the opening
G
until the countertop fully engages the
control panel. The back glass overhang
should cover the cutout opening.
Make sure the edge of
the countertop fits flush
against the end of the
front control panel
Installation Instructions
(CONT.)
Countertop
10
SLIDE RANGE INTO OPENING
13
(cont.)
Plug the range cord into the receptacle.
H
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
Position range cord
so that there is no
interference with
storage drawer
STORAGE DRAWER
FINAL CHECK OF ANTI-TIP
14
BRACKET
When installation is complete and the range is
in place, check to be sure that the rear leveling
leg is fully inserted into the slot of the Anti-Tip
Bracket.