Directed Electronics Cyber 130XV User Manual page 41

r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Directed system will store its current state to non-volatile
memory. If power is lost and then reconnected the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
®
as servicing the car, when the battery is reconnected the unit will
still be in Valet
including arm, disarm, and Valet
p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw on
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤ Power Saver when the system is armed: After the system has
been armed for 24 hours the in-vehicle status LED will flash
at half its normal rate, decreasing the system's current draw.
© 2004 directed electronics, inc.
Mode. This applies to all states of the system
®
Mode, after a period of time in which no
®
Mode.
®
37