D-Link DIR-645 User Manual page 62

Section 3 - Software Configuration
The following parameters will be available for configuration:
Enable DHCP-
Select this option to enable DHCP PD.
PD:
LAN IPv6
Enter the LAN IPv6 address used here. This address
Address:
must be in the '/64' subnet.
LAN IPv6 Link- Displays the LAN IPv6 Link-Local address used
Local Address: here.
The following parameters will be available for configuration:
Enable The user can tick this option to enable the auto-
Automatic IPv6 configuration feature.
address:
Enable Tick this option to enable the automatic DHCP-PD
Automatic on the LAN.
DHCP-PD in LAN:
The user can select the auto-configuration type
used here.
Router
This option is only available when the auto-
Advertisement configuration type is set to Stateless. Enter the
Lifetime:
router advertisement lifetime value used here.
IPv6 Address
This option is only available when the auto-
Range (Start): configuration type is set to Stateful. Enter the
start IPv6 Address for the DHCPv6 range for your
local computers.
IPv6 Address This option is only available when the auto-
Range (End): configuration type is set to Stateful. Enter the end
IPv6 Address for the DHCPv6 range for your local
computers.
IPv6 Address This option is only available when the auto-
Lifetime: configuration type is set to Stateful. Enter the IPv6
Address Lifetime (in minutes).
Click on the Save Settings button to accept the changes made.
Click on the Don't Save Settings button to discard the changes made.
D-Link DIR-645 User Manual 58