Table of Contents
Advertisement
used for many different purposes if you use FXMods to control it. FXMods can set the gain of
the signals going to the various FXBuses, set panning and output levels of the signals from the
buses, conÞgure the mix going to the Aux bus, and even turn FXBuses on or off, as well as set
processing parameters.
Since any parameter except the ones that reconÞgure a studio (see What CanÕt Be
Controlled on page 15-24) can be under FXMod control, the amount of variation between the
various program- or setup-controlled versions of a single studio can be very great.
Static FXMods
Static FXMods, that is, FXMods that are just going to be used to Òset and forgetÓ studio
parameters when a program or studio is called up (as opposed to dynamically controlling
them), are easy to set up. On the FXMOD page, select the bus and parameter you want to
control, set the Adjust value to the parameter value you want, and set Source to OFF. When you
are done, save the program or setup normally. Now whenever you select the program or setup,
the parameters in the FXMods will be immediately reset to the values youÕve speciÞed.
Room Type and other potentially glitch-producing parameters work much better as static
FXMods than they do under dynamic control. If you need to change a Room Type in a reverb
when you change a program, you can do so with a static FXMod without hearing horrible
glitches, as long as you make sure there is no signal passing through the reverb at the moment of
the program change.
Importing Studios From Another Program or Setup
If you have a killer studio with FXMods set up in one program (or setup) and you want to use
the same studio and FXMods in a different program, you donÕt have to rebuild the studio by
hand: you can copy studios between programs or setups in one operation.
Press the ImpFX soft button, and youÕll see this:
Edit Program:Import KDFX
From|Program||200*My|Orchestral|Studio||
(Studio 41|auxChorTube|Plt|||)|
Prog||Setup||||||||||||||||||Import|Cancel
Use the soft buttons at the left to select either a program or a setup as the source for the studio
and FXMods you are importing. Select the number of the program or setup you want to import
from. As you change the program or setup, the studio associated with each program or setup
will display in parentheses below the program or setup.
The studio will also kick in, so you can hear it affecting the program youÕre listening to.
When youÕve chosen a program or setup to import a studio from, press the Import soft button.
ÒKDFX fromÉimportedÓ will ßash on the screen, and you will be returned to the Program
Editor of the program or setup you are working on.
Studios from setups can be imported into programs without restriction, and vice versa.
Advanced KDFX
Real-time Control of KDFX
15-27
Advertisement
Table of Contents
