IBM 17353LX - 1x8 Console Switch Installation And User Manual page 53

ATTENTION: Monitor damage can result from the use of Energy mode with monitors not compliant with
E S .
NERGY TAR
5. (Optional) Click Test to activate the screen saver test, which lasts 10 seconds then returns you
to the Security window.
6. Click OK in the Security window to save the changes.
-or-
Click X or press Esc to exit the window without saving changes.
NOTE: After the specified Inactivity Time, the screen saver turns on. Activation of the screen saver disconnects
the current user from a server. The status flag displays Free.
Exiting the screen saver mode
1. Press any key or move the mouse.
2. If logging in is required, the login window opens. If logging in is not required, the screen saver
quits, the Main window opens and any previous server connections are restored.
3. If the login window opens, enter the required login information for your account, and then
click OK.
Removing password protection
NOTE: If the Security window displays as shown in Figure 3.13, this procedure removes the password for a
regular user. If the Security window displays as shown in Figure 3.12, the procedure removed the password for
the Admin user and enables unrestricted access by anyone with physical access to a local user station.
1. Access the Security window. If needed, see "Accessing the Security window" on page 37.
2. Click in the New field and press Enter or double-click in the New field. Leave the field blank.
3. Click in the Repeat field and press Enter or double-click in the Repeat field. Leave the field
blank.
4. Click OK in the Security window to save the changes and then click X or press Esc to exit the
window.
-or-
Click X or press Esc to exit the window without saving changes.
Turning off the screen saver
1. In the Security window, clear the Enable Screen Saver check box.
2. Click OK in the Security window.
-or-
Click X or press Esc to exit the window without saving changes.
Turning on the screen saver
After the screen saver is enabled, press Print Screen+ Pause.
Chapter 3: Using the OSCAR Interface 39