Two-Vehicle Operation With Single Transmitter - Directed Electronics 430 Series Installation Manual

Table of Contents

You can get two-vehicle operation with the transmitters that come with the system. However, you cannot use all the

auxiliary channels of the system (or all the auxiliary channels of the other system), unless using a 485T 4-button

transmitter.

Here's what to do:

1. Using Learn Routine™, program Button I into system # 1 as the arm/disarm button. Do this with all four

remotes.

2. Do the same with system # 2, except program Button II of all four remotes as the arm/disarm button.

If using DEI

485T four-button remotes, all auxiliary channels are available on both vehicles. Before program-

ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.

For example, if you wanted the top two buttons to control vehicle # 1 and the bottom two buttons to control vehicle

# 2, here is how each system would be programmed:

Vehicle # 1:

Button I = arm/disarm.

Button II = trunk release/Silent Mode

Button I+II = channel two. (Instant)

Vehicle # 2:

Button III = arm/disarm.

Button IV = trunk/release/Silent Mode

Button III+IV = channel two. (Instant)

Technical Manuals Online! - http://www.tech-man.com

N430 9/99

TWO-VEHICLE OPERATION WITH SINGLE TRANSMITTER

™

Table of Contents