Oem Style Configurations; Two Vehicle Operation With A Single Transmitter - Directed Electronics 100 ESP Installation Manual

oem style configuration
A remote that uses the OEM Style Configuration operates similarly to many factory keyless entry remotes. An OEM
Style Configuration transmitter allows arming and disarming with separate buttons. When programmed for OEM
Style Configuration, the transmitter buttons are assigned to the following functions:
Button I ...........................operates.........................Arm/Panic
Button II ..........................operates.........................Disarm/Channel 2
Buttons I and II ................operate ..........................Channel 3
two vehicle operation with single transmitter
You can get two-vehicle operation with the transmitters that come with the system; however, you will not be
able to use all the auxiliary channels of the system (or all the auxiliary channels of the other system), unless
using a 475T 4-button transmitter.
Here's what to do:
1. Using the Learn Routine, program Button I into System One as the arm/disarm button. Do this with all four
remotes.
2. Do the same with System Two, except program Button II of all four remotes as the arm/disarm button.
If using DEI ® 475T four-button remotes, all auxiliary channels are available on both vehicles. Before program-
ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.
For example, if you wanted the top two buttons to control Vehicle One and the bottom two buttons to control
Vehicle Two, here is how each system would be programmed:
© 1999 Directed Electronics, Inc. Vista, CA
VEHICLE 1
Button I
Button II
Buttons I and II
VEHICLE 2
Button III
Button IV
Buttons III and IV
Arm/Disarm/Panic
Channel 2
Channel 3
Arm/Disarm/Panic
Channel 2
Channel 3
19