Table of Contents
Advertisement
Novell ZENworks Application Virtualization
7.7 Deploying using the Publish to USB feature
This section describes how to deploy virtual applications to USB storage devices using the Publish to USB
feature.
Publishing virtual applications to USB storage devices
The Publish to USB feature publishes virtual applications to USB storage devices. When the USB storage
device is attached to a host system, the virtual application automatically registers the Setup information to the
host shell environment. This information is automatically unregistered when the USB device is removed from
the host system.
Follow the steps below to deploy virtual applications on USB devices:
1. Open an existing virtual application configuration.
2. Attach a USB storage device to the host system.
3. Click Publish to USB, select the USB storage device, and click Publish.
4. After the virtual application is published to the USB storage device, click OK.
Using virtual applications from USB storage devices
Follow the steps below to virtual applications that are published to USB storage devices:
1. Attach the USB storage device to the host system.
2. (If prompted by AutoPlay, choose the XUsb.exe option. XUsb will then register the file associations and
shortcuts associated with the virtual application.)
3. Remove the USB storage device to unregister the virtual applications from the host system.
If AutoPlay is disabled on the host system, open the USB storage device's contents and manually run
XUsb.exe.
60
Advertisement
Table of Contents
