Repair Parameters; Restart Options; Section A.3, "Repair Parameters; The Following Sections Contain Additional Information - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

A.3 Repair Parameters
The Repair Parameters dialog box lets you specify the desired parameters.
Repair Parameters Dialog Box
Figure A-3

The following sections contain additional information:

Section A.3.1, "Restart Options," on page 99
Section A.3.2, "Display Options," on page 100
Section A.3.3, "Repair Options," on page 100
Section A.3.4, "Command Line Parameters," on page 101

A.3.1 Restart Options

In some cases, repairing an application requires restarting the workstation.
In the Repair Parameters dialog box, select the desired Restart option:
None (default): Uses the MSI application's settings to determine whether or not a restart occurs.
ZENworks does not force a Restart option.
Do Not Restart (/norestart): Never restarts the workstation during the repair process. The repair
process is not completed until the next time the workstation starts.
Prompt For Restart (/promptrestart): Prompts users before restarting the workstation. If users
answer No, the repair process is not completed until the next time they manually restart.
Install, Uninstall, and Repair Parameters 99