Action - Verify Bundle; Section E.33, "Action - Verify Bundle - Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - SOFTWARE DISTRIBUTION REFERENCE 10.3 30-03-2010 Management Manual

Action - Uninstall Bundle Dialog Box
Figure E-36
You access this dialog box by using the following methods:
As part of the process of creating a Directive bundle by using the Actions bundle category. For
more information, see
In ZENworks Control Center, click the Bundles tab, click the underlined link of a bundle in the
Name column of the Bundles list, click the Actions tab, click one of the action set tabs (Install,
Launch, Verify, Uninstall, Terminate, or Preboot), click the Add drop-down list, then select an
available action.
Click to browse to and select the bundle to uninstall from the device.
The Look in list defaults to
down-arrow to select the appropriate folder. The Items of type list defaults to All Types so that all
types of bundles are displayed (Directive, File, Imaging, and Windows bundles). If you know the
name of the bundle you are looking for, you can use the Item name box to search for the bundle.
You must not use the Uninstall Bundle action to uninstall Directive bundles.
Creating this action creates a bundle dependency. For more information, see
"Dependency Bundles," on page
E.33 Action - Verify Bundle
The Action - Verify Bundle dialog box lets you verify a bundle on the device.
Verifying a bundle ensures that the specified bundle or bundle group has been properly installed on
the device.
For example, for an MSI bundle, verifying the bundle results in the task running an MSI /repair
process against the bundle.
Action - Verify Bundle Dialog Box
Figure E-37
Section 2.1, "Creating Directive Bundles," on page
. If you have created subfolders to hold your bundles, use the
/Bundles
13.
19.
Section 1.4,
Actions 175