Novell ZENWORKS 10 CONFIGURATION MANAGEMENT SP3 - REMOTE MANAGEMENT REFERENCE 10.3 Management Manual page 28

Password Authentication
Field
Enable Password Based
Authentication
Minimum Password Length
Session Password
Persistent Password
ZENworks Password
VNC Password
28 ZENworks 10 Configuration Management Remote Management Reference
Details
Allows the remote operator to use a password to authenticate to
the managed device. Select this option to configure the password
type settings.
Allows you to specify the minimum length for the password. By
default, it is 6 characters.
Select this option to prompt the user on the managed device to set
a password before the start of a new remote session. This option is
recommended because the password is not stored on the
managed device and is valid only for the current session.
Select this option to set the ZENworks and VNC passwords.
Setting the ZENworks Password is recommended because it is
safer and more secure than the VNC Password. This password
can be set by the administrator through the Remote Management
policy or by the managed device user from the ZENworks icon.
Selecting this option enables the subsequent options.
To enable the user to set the password through the ZENworks
icon, select the Allow user to override default passwords on
managed device option.
To clear the ZENworks password:
1. Click Clear Password.
2. Click Apply, then click OK.
To set the ZENworks password:
1. Click Set Password.
2. Enter the password. The maximum length of the password is
255 characters.
3. Click Apply, then click OK.
To clear the VNC password:
1. Click Clear Password.
2. Click Apply, then click OK.
To set the VNC password:
1. Click Set Password.
2. Enter the password. The maximum length of the password is
8 characters.
3. Click Apply, then click OK.