Table of Contents
Advertisement
4 Start the installation from CD-ROM, DVD, or the network. See also Section "Set-
5 Install the software and perform the basic network configuration. See also
4.2 Installing in an LPAR
1 Verify the hardware requirements. See also Section "Hardware Requirements"
2 Verify the software requirements. See also Section "Software Requirements"
3 Prepare a VNC client for the installation process. See also Section "Simple Re-
4 Prepare the system in its firmware or on the i5/OS side:
16
Start-Up Guide
also applies for ATX workstation and ATX server (only for the installation
on an entire system).
• For eServer i5/p5, System i5/p5, and OpenPower, see also Section "Preparing
for Installation on IBM eServer i5/p5, System i5/p5, and OpenPower Models"
(Chapter 2, Preparation, ↑Architecture-Specific Information).
• For JS20/JS21 Blades, see also Section "Preparing an Installation on IBM
JS20/JS21 Blades" (Chapter 2, Preparation, ↑Architecture-Specific Informa-
tion).
ting Up the Installation Source" (Chapter 2, Preparation, ↑Architecture-Specific
Information).
Chapter 3, Installation with YaST (↑Installation and Administration).
(Chapter 1, Requirements, ↑Architecture-Specific Information).
(Chapter 1, Requirements, ↑Architecture-Specific Information).
mote Installation via VNC—Static Network Configuration" (Chapter 4, Remote
Installation, ↑Installation and Administration).
• For iSeries, see also Section "Preparing an Installation on IBM iSeries
Models" (Chapter 2, Preparation, ↑Architecture-Specific Information)
• For pSeries p630, p655, p670, and p690, see also Section "Preparing for In-
stallation on an IBM pSeries Models" (Chapter 2, Preparation, ↑Architecture-
Specific Information)
Advertisement
Table of Contents
