Installing In An Lpar - Novell LINUX ENTERPRISE DESKTOP 10 SP1 - START UP GUIDE 03-15-2007 Manual

4 Start the installation from CD-ROM, DVD, or the network. See also Section 2.2.3,
5 Install the software and perform the basic network configuration. See also

4.2 Installing in an LPAR

1 Verify the hardware requirements. See also Section 1.1, "Hardware Requirements"
2 Verify the software requirements. See also Section 1.2, "Software Requirements"
3 Prepare a VNC client for the installation process. See also Section 4.1.1, "Simple
4 Prepare the system in its firmware or on the i5/OS side:
16 Start-Up Guide
tion). This also applies for ATX workstation and ATX server (only for the
installation on an entire system).
• For eServer i5/p5, System i5/p5, and OpenPower, see also Section 2.1,
"Preparing for Installation on IBM eServer i5/p5, System i5/p5, and Open-
Power Models" (Chapter 2, Preparation, ↑Architecture-Specific Information).
• For JS20/JS21 Blades, see also Section 2.3, "Preparing an Installation on
IBM JS20/JS21 Blades" (Chapter 2, Preparation, ↑Architecture-Specific
Information).
"Setting Up the Installation Source" (Chapter 2, Preparation, ↑Architecture-
Specific Information).
Chapter 3, Installation with YaST (↑Installation and Administration).
(Chapter 1, Requirements, ↑Architecture-Specific Information).
(Chapter 1, Requirements, ↑Architecture-Specific Information).
Remote Installation via VNC—Static Network Configuration" (Chapter 4, Remote
Installation, ↑Installation and Administration).
• For iSeries, see also Section 2.4, "Preparing an Installation on IBM iSeries
Models" (Chapter 2, Preparation, ↑Architecture-Specific Information)
• For pSeries p630, p655, p670, and p690, see also Section 2.2, "Preparing
for Installation on an IBM pSeries Models" (Chapter 2, Preparation, ↑Archi-
tecture-Specific Information)