Install And Charge Battery - Gigabyte GSmart MS802 Quick Manual

Connections
Signal
Message
Data call.
You have missed calls.
Voice call in active.
3G network is
connected.
GPRS is in range.
GPRS is connected.
Building connection to
GPRS.
Bluetooth is activated.
Wi-Fi is activated; a
Wi-Fi network is in
range; Wi-Fi network
is connected.
Strong signal.
No signal.
Roaming.
GPS signal is trying to
connect, and is
connected.
GPS Tracking is trying
to connect.
GPS Tracking is
connected.
Location Message
GPS signal is trying to
detect.
Location Message
GPS signal is
detected.
You have one or more
new message(s).
Volume
Quick Menu

Install and Charge Battery

When you use the device for the first time, please
make sure the battery is installed and is charged
fully.
1. Insert a battery to the battery slot.
2. Plug your charger into an outlet, and plug the
other end to your device. The device will start
charging automatically.
3. It takes 3 hours to fully charge your battery with
a traveler charger for the first time. Besides, it
takes 6-8 hours to fully charge your battery with
a battery charger for the first time. Unplug the
device from the charger, when the charging is
completed, and then you may use the device.
4. When the LED light is in red, it means the
battery is charging.
5. When the LED light is in green, it means the
charging is completed.
6. The battery icon
screen shows the battery status. You may also
check the battery status in Start > Settings >
System tab > Power > Battery tab.
MS802│ 04
You have one or more
new voice mail(s).
You have one or more
instant message(s).
System volume.
Phone volume.
Ringer is on.
Ringer is off.
Memory Management,
Adjust Brightness,
Quick Menu Setting.
on task bar on Today