Selecting The Scene Templates; Selecting The Desired Scene Template - Yamaha HTR 6230 - AV Receiver Owner's Manual

Just by pressing one SCENE button, you can recall your
favorite input source and sound field program according to
the SCENE template that has been assigned to the SCENE
button. The SCENE templates are built combinations of
input sources and sound field programs.
This unit is equipped with 13 preset SCENE templates for
various situations. The following SCENE templates are
assigned to respective SCENE buttons in the default
settings.
Default SCENE The name of the SCENE template and
button
DVD Viewing
– input source: DVD
SCENE 1 – sound field program: STRAIGHT
For when you want to enjoy a DVD
playback.
Disc Listening
– input source: DVD
– sound field program: 5ch Stereo
SCENE 2
For when you want to listen to a music disc
from the connected DVD player as the
background music for this room.
TV Viewing *1
– input source: DTV/CBL
SCENE 3
– sound field program: STRAIGHT
For when you want to watch a TV program.
Radio Listening *2, *3, *4
– input source: TUNER
SCENE 4 – sound field program: Music Enh. 5ch
For when you want to listen to a music
program from the FM radio station.
Notes
*1 You must connect a cable TV or a satellite tuner to this unit in advance.
See page 13 for details.
*2 You need to connect the supplied FM and AM antennas to this unit in
advance. See page 15 for details.
*3 You have to tune into the desired radio station. See pages 27 to 28 for
the tuning information.
*4 To achieve the best possible reception, orient the connected AM loop
antenna, or adjust the position of the end of the indoor FM antenna.

Selecting the SCENE templates

its description

Selecting the desired SCENE template

If you want to use other SCENE templates, you can select
the desired SCENE templates from the SCENE template
library and assign the templates to the selected SCENE
buttons on the front panel and the remote control.
Select the desired SCENE template
SCENE template library
(Image)
1
Press and hold the desired JSCENE (or
iSCENE) button for 3 seconds.
The MEMORY indicator on the front panel starts to
flash, and the name of currently assigned SCENE
template appears on the front panel display.
D V D V i e w i n g
2
Press NINPUT l / h (or press hAMP and
then ll / h) to select the desired template.
D V D M o v i e V i e w
3
Press the JSCENE (or iSCENE) button
again to confirm the selection.
The MEMORY indicator stops flashing and the select
SCENE template is assigned to the button.
y
• To cancel the procedure, press hAMP and then nRETURN.
Note
• Once the desired SCENE templates are assigned to the corresponding
SCENE buttons, you may need to set the input source of the SCENE
template on the remote control. See page 24 for details.
1
Assign the
SCENE template
to the SCENE
button
21
En