Password Setup; Device Lock; System Reboot And Reset; Protect Your Screen - Gigabyte GSmart i350 User Manual

Information" and "Note".
6. Select "OK" to finish setup and save it.

1.10 Password Setup

You can set your own password to prevent
unauthorized use of your device.
1. Tap Start > Settings > Personal Tab > Lock
> Password Tab.
2. On Password tab screen, check "Prompt if
device unused for".
3. Select an appropriate time.
4. Select a password type in "Password Type"
field.
5. Input your password in the "Password" field
and reconfirm the password in "Confirm".
6. Tap "OK", a pop-up window will appear to
confirm "Do you want to save password
settings changes?"
7. Tap "Yes" to finish settings and save the
changes; "No" to cancel.
8. You may also input password hint message
under the Hint tab screen.
9. Tap "OK" to save your inputs.
Note: If you forget your password, you
need to perform system default,
which will lose all your data and

1.11 Device Lock

On "Today" screen, tap "Device unlocked" to
lock your device. When the device is locked,
the device will not respond to touches on
screen nor will it react to any input on the
keypad. You can enable device lock after
entering Sleep mode by pressing the power
key. To enable this setting, please follow the
steps below:
1. Tap Start > Settings > System Tab > Power
> Extended Tab
2. Check "Lock device when device enter
stand-by".
Unlock device:
1. Tap "Unlock" on the bottom left of the
screen, or press the left function key.
2. Tap the "Unlock" button on the newly
appeared screen and the device is
unlocked.

1.12 System Reboot and Reset

Reboot System:
When you reboot the device, all running
programs will stop and you will lose all
unsaved information. Please make sure that all
information has been saved before performing
system reboot.
1. Reboot button is located on the bottom right
side of your device.
2. Use the stylus to softly poke the reboot
button on the lower right side of the device
to reboot your system.
System Reset:
When executing system reset, you are
performing a clean boot on the device. It will
remove the programs you have installed on
this device, and reset all settings and
information back to factory defaults.
1. Turn off the device.
2. Press the Flag key and OK key at the same
time, and press Power key while still
holding Flag key and OK key.
3. This device will restore to system defaults
and reboot.

1.13 Protect Your Screen

To avoid damaging your device screen and
camera lens, please do not drop, smash, or
place pressure on the device.

1.14 Maintenance

1-5
i350