Install Memory - JETWAY I405R4A User Manual

When you put the CPU into the ZIF socket. No force require to insert of the CPU,
then press the level to Locate position slightly without any extra force.

2-4 Install Memory

This motherboard provides
(DIMM) sites for memory expansion available from minimum memory size of
64MB to maximum memory size of 3.0GB SDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DIMM1)
Bank 2, 3 (DIMM2)
Bank 4, 5 (DIMM3)
Total
NOTE! Make sure the installed memory are PC133 SDRAM support 133MHz memory
clock, otherwise the system may hang during startup.
Generally, installing SDR SDRAM modules to your motherboard is very easy, you
can refer to figure 2-4 to see what a 168-Pin PC133 SDR SDRAM module looks
like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the SDR SDRAM CLOCK is set at 133MHz, use only PC133-
compliant SDR Modules. When this motherboard operate at 133Mhz,
most system will not even boot if non-compliant modules are used because
of the strict timing issues, if your SDR Modules are not PC133-compliant,
set the SDR SDRAM clock to 100MHz to ensure system stability.
three 168-pin DUAL INLINE MEMORY MODULES
168-Pin DIMM
PC133 SDR SDRAM Module
PC133 SDR SDRAM Module
PC133 SDR SDRAM Module
System Memory (Max. 3.0GB)
10
Total Memory
X1 64MB∼1.0GB
X1 64MB∼1.0GB
X1 64MB∼1.0GB
3 64MB∼3.0GB
Figure 2-4