Table of Contents
Advertisement
COM1/COM2A is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(9)
Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
(11) Secondary IDE Connector (40-pin block): IDE2
PS/2
Mouse
LAN
PRINT
PS/2
USB
COM1
Keyboard
FDD
Floppy Drive Connector
IDE1
Pin 1
14
GAME/MIDI PORT
COM2
Pin 1
MIC
LINE-IN
LINE-OUT
Advertisement
Table of Contents
