Table of Contents
Advertisement
Do not use AGP 2X card (3.3V) in this motherboard.
motherboard due to Intel® 848 chipset can not support AGP 2X (3.3V).
IMPORTANT!
Example 1:
SiS 305 & ATi Rage 128 Pro AGP card those golden finger is compatible
with 2X/4X mode AGP slot, but only can support 2X (3.3V) only. If you
install these cards in Intel® 848 based motherboard it will burn and damage
the motherboard.
Example 2:
We also find Diamond Vipper V770 golden finger is design for 2X/4X mode
AGP Slot. It can be adjusted the jumper for AGP 2X (3.3V) or AGP 4X
(1.5V). But the factory default setting is 2X (3.3V). If you install this AGP
card in motherboard without change the jumper setting to 4X (1.5V), it will
burn the motherboard.
2-6 Connectors, Headers
2-6-1 Connectors
(1)
Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually comes
with ATX case. The ATX Power Supply allows to use soft power on momentary switch that
connect from the front panel switch to 2-pins Power On jumper pole on the motherboard.
When the power switch on the back of the ATX power supply turned on, the full power will not
come into the system board until the front panel switch is momentarily pressed. Press this
switch again will turn off the power to the system board.
Before you plug-in AGP card, please make sure the following notice is
fully understood and practiced. If your AGP card has "AGP 4X notch
(show below) please make sure your AGP card is AGP 4X/8X
(1.5V/0.8V) not AGP 2X (3.3V)
It will burn and damage the
2x notch
12
4x notch
AG P SLO T
Advertisement
Table of Contents
