Table of Contents
Advertisement
The Power LED is light on while the system power is on. Connect the Power LED
from the system case to this pin.
(8)
Power switch: PWR BTN
This 2-pin connector connects to the case-mounted power switch to power ON/OFF the
system.
(9)
Wake On-LAN Headers (3-pin) : WOL
This connector connects to a LAN card with a WAKE ON-LAN output. This connector
power up the system when a wake up signal is received through the LAN card.
NOTE: This feature requires that Wake On LAN or Ring In Wake up is enabled.
(10) FAN Speed Headers (3-pin) : SYSFAN, SYSFAN2, CPUFAN
These connectors support cooling fans of 350mA (4.2 Watts) or less, depending on the
fan manufacturer, the wire and plug may be different. The red wire should be positive,
while the black should be ground. Connect the fan's plug to the board taking into
consideration the polarity of connector.
SPEAKER
Pin 1
FP
PWRBT
G ND
PWRBTN
ACPILE D
HDDLE D
PWR LE D
VC C5
Pin 1
System Case Connections
WOL
3
WO L
GND
5VSB
1
Wake-On-LAN Headers
CPUFAN
3
1
SYSFAN2
3
1
1
3
SYSFAN
FAN Speed Headers
17
VC C5
G ND
NC
SPKR
NC
RESET
RSTSW
G ND
HDLED
VCC5
Advertisement
Table of Contents
