Playback Functions Screen; Av Out Setup Screen - Panasonic AGHPG10 - MEMORY CARD PORTABLE RECORDER Operating Instructions Manual

PLAYBACK FUNCTIONS screen

Item
REPEAT PLAY
AUDIO OUT

AV OUT SETUP screen

Item
CMPNT/SDI SEL
SDI OUT
SDI METADATA
SDI EDH
SETUP
(60 Hz regions only)
This is used to set repeat playback.(Page 43)
Playback is repeated.
ON:
Playback is not repeated.
OFF:
This is used to set the audio signals to be output from the AUDIO OUT connectors
(pin jacks) during playback.
CH1 · CH2:
CH1 connector = CH1 signal, CH2 connector = CH2 signal,
CH1:
CH1 connector = CH1 signal, CH2 connector = CH1 signal,
CH2:
CH1 connector = CH2 signal, CH2 connector = CH2 signal,
CH3 · CH4:
CH1 connector = CH3 signal, CH2 connector = CH4 signal,
CH3:
CH1 connector = CH3 signal, CH2 connector = CH3 signal,
CH4:
CH1 connector = CH4 signal, CH2 connector = CH4 signal,
This is used to set the format when D connector signals and HD/SD-SDI signals are
output.
(60 Hz regions)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 480i
(50 Hz regions)
AUTO:
Operation reflects the setting selected for the SYS FORMAT item on the
RECORDING SETUP screen.
1080i, 576i
This is used to set the SDI output.
SDI signals are output.
ON:
SDI signals are not output.
OFF:
This is used to set whether to superimpose the meta-data when HD-SDI signals are
output.
The meta-data is superimposed.
ON:
The meta-data is not superimposed.
OFF:
This is used to set whether to superimpose error detection handling (EDH) when SD-
SDI signals are output.
EDH is superimposed.
ON:
EDH is not superimposed.
OFF:
The setup level of the video signals during playback is set.
0%:
0% is set as the output setup level.
7.5%A:
7.5%A is set as the output setup level.
Description of settings
Description of settings
The underlined settings are the factory mode settings.
75