Table of Contents
Advertisement
18
4.
Start - Pull Rope.
Lay the unit on a flat clear area and pull the recoil starter handle
(E) until engine fires.
5.
Open Choke - Run.
Move the choke lever to the OPEN-RUN position. Restart engine
if necessary and allow to warn up running at idle for several
minutes.
NOTE
If engine does not start with choke in "RUN" position after 5 pulls,
repeat instructions.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
STARTING WARM ENGINE
WARNING
The cutting attachment should not move at idle. If cutting attach-
ment moves, readjust carburetor according to "Carburetor Adjust-
ment" instructions in this manual or see your ECHO Dealer,
otherwise serious personal injury may result.
1. Stop Switch - Start/Run.
Move stop switch button/lever (A) away from the STOP position.
2. Primer - Pump Bulb.
Pump primer bulb (C) until fuel is visible and flows freely in the clear
fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Starting.
Lay unit on a flat, clear area and pull recoil starter handle/rope (D)
until engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
DANGER
D
A
C
D
Advertisement
Table of Contents
