TYAN TRINITY 100AT Manual page 25

Figure 2-12 Figure 2-13
Make absolutely certain that you do not miss any pins, because if you do you
will void your warranty and cause damage to yourself or your motherboard
when you turn the system on. After connecting the power, make sure the
connector is seated firmly into its socket so it will not become loose or fall off
warning
when the computer is jostled or moved. Note: If you use an ATX power supply,
Tyan recommends using one that conforms to industry standard revision 2.01.
If you decide to use an AT power supply instead, connect the power supply to
the board as shown in Figure 2-14 (on the following page). You must set
jumper JP7 according to which type of power supply you have (see p.15).
Note that the black wires are in the center of the two connectors. You should
not be able to plug the two power connectors in any other way but just to be
safe, make sure you have them connected as shown above. Make absolutely
certain that you do not miss any pins because if you do, you will void your
warranty and cause damage to yourself or your motherboard when you turn
the system on. After connecting the power, make sure the connectors are
seated firmly into their sockets so they will not become loose or fall off during
movement of the computer.
S1590 Trinity 100AT
25