Wiring - Jensen MPX6411 - Radio / CD Instruction Manual

MPX6411

WIRING

Wiring with a Wiring
Adapter (Purchased
Separately)
Connect Wires
You can make all these
connections without even being
in the vehicle.
1. Splice or crimp wires.
2. Attach wiring adapter to the
car wiring harness.
Wiring Diagram / Color Codes
1. Power Antenna (dark blue
wire) - Connect to the power
antenna or a amplifier. If not
used, tape the bare end of
wire.
2. Ground (black wire) -
Connect to the ground
terminal or a clean,
unpainted part of the
chassis.
3. Memory/Battery (yellow
wire) - Connect to the
battery or to a 12 volt power
source that is always alive.
The radio will not work if this
wire is not connected.
4. Accessory/Ignition (red wire)
- Connect to the existing
radio wire or radio fuse.
5. Left front speaker
6. Right front speaker
7. Left rear spearker
8. Right rear speaker
9. RCA Outputs to Amplifier
10. Auxiliary Input Cable
(yellow)
11. Antenna
®
12. XM Direct Connect Cable
®
13. XM Audio Input (black RCA)
14. Subwoofer Output (blue)
15. CD Changer/JPORT connector - Use this 8-pin DIN socket to connect an optional CD
Changer or JPORT (sold separately).
*TERK XMDJEN100 cables sold separately.
**TERK XMD1000 Direct Tuner and antenna sold separately.
NOTE: The amplifier in this radio is only designed for use with four speakers. Never
combine (bridge) outputs for use with two speakers. Never ground negative speaker
leads to chassis ground. Failure to wire exactly as shown may cause electrical damage
to the radio.
3