TYAN TIGER 200 User Manual page 44

Creating an array for Performance (RAID 0)
FastTrak100 allows users to create striped arrays with 1, 2, 3, or 4 drives. To create your array, follow the
steps outlined below.
1
Step
Choose Performance under the Optimize Array section.
2
Select how you will use your PC the mode under the Typical Application usage section. The
Step
choices are A/V Editing, Server, and Desktop (the default).
3
Step
Press <Ctrl-Y> keys to Save and create the array.
4
Step
Reboot the system.
5 Proceed to install the drivers from the driver disk.
Step
Creating a Security Array with New Drives (RAID 1)
To create an array for data protection using new hard drives, use the following steps.
FastTrak100 permits only two drives to be used for a single Mirrored array in Auto
NOTE: Setup. If a third drive is attached, it becomes a "hot" spare drive. If four drives are
attached, the Mirroring option will not be available at all.
1
Step
Choose Security under the Optimize Array for section.
2 Press <Ctrl-Y> keys to Save your selection.
Step
3
Step
The window below will appear.
Do you want the disk image to be duplicated to another? (Yes/No)
Y - Create and Duplicate
N - Create Only
Press "N" for the Create Only option.
4
Step
A window will appear almost immediately confirming that your Security array has been created.
5
Step Press any key to reboot the system.
Once the arrayed drives have been formatted, proceed to install your O/S and drivers from the
6
Step
driver disk.
44
Array has been created.
<Press Any Key to Reboot>
http://www.tyan.com