Fraid Ide Ports; G Onboard Video Enable/Disable; Hagp Irq Enable/Disable; I Auto Cpu Frequency Jumper - TYAN TIGER 200 User Manual

2.6-F. RAID IDE ports (RAID PIDE, RAID SIDE)
These are the IDE RAID ports. Their functionality is determined by J25 (see Section E, p. 12).
2.6-G. Onboard Video Enable/Disable (JP3)
close
JP3
disable
You can enable or disable the onboard video controller by
using this jumper. The settings are shown in the table above.
2.6-H. AGP IRQ Enable/Disable (J10)**
close
J10
disable
You can enable or disable the AGP IRQ by using this jumper.
The settings are shown in the table above.
2-6-I. Auto CPU Frequency Jumper (JP1)**
close
JP1
auto-detect 100 or 133
Default is for JP1 is AUTO-DETECT. NOTE: The CPU frequency is dependent on the CPU's pre-set bus
frequency. Tyan takes no liability for damage related to the incorrect setting of the jumper.
2.6-J. Infrared connector (J16)
This is the connector for an infrared device.
2.6-K. Serial Port connector (COM1)
This is the connector for a second serial port.
2.6-L. Parallel Port (PJ2)*
This is the connector for a parallel port*. It has been provided should you decide to add an external paral-
lel port.
2.6-M. Option (D35)**
This is an optional reserved socket, available on some Tiger 200 S2505 models.
2.6-N. Option Jumpers (J18, 19, J20)**
These are optional jumpers, related to D35's function.
2.6-O. Wake on LAN (J7)**, Wake on Ring (J8)**
For WOL and WOR functions (respectively). Check Tyan website for details: http://www.tyan.com
* extra accessories can be purchased at the Tyan Online Store: http://www.etyan.com
** optional feature available on some models of Tiger 200 S2505
Tiger 200 S2505
open
enable
open
enable
open
PJ2
J7 J8
J10
RAID
JP3
PIDE
COM1
J16
JP1
J18
J19
J20
RAID
SIDE
13