HighPoint ATA-133 RAID User Manual page 40

RAID Administrator
Then the follow-up window will appear as below:
Just select the broken array, then click OK and confirm the follow-up data loss
warning message box to finish the rebuilding of the selected broken RAID 1
array. After rebuilding, the new array will be automatically duplicated to rebuid
the lost data.
(2)Hot swapping a hard disk to rebuild broken RAID 1 or RAID 0+1 array
Follow these steps to rebuild by this way:
Hot swap on a good hard disk(user may need to hot swap off the failed disk first),
then within the ATA RAID software click
the devices connected. After refreshing, the ATA RAID software will find new
disk plugged, see below:
Just click OK, the following window will popup to prompt user whether to use
this newly plugged disk to rebuild the broken array, see below:
Management --> Refresh tab to refresh
3-16