TYAN NETSCALIBUR Manual
  1. Manuals
  2. Brands
  3. TYAN Manuals
  4. Computer Hardware
  5. NETSCALIBUR
  6. Manual
TYAN NETSCALIBUR Manual

TYAN NETSCALIBUR Manual

Internet accelerator card
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Quick Start .................................................................................. 2
What is the Netscalibur .............................................................. 3
Inside the Box ............................................................................. 3
System Requirements ................................................................. 4
Cable Connection ........................................................................ 4
On-Line Browser Manual ................................................................... 5
ISDN Diagnostic Tool ................................................................. 6
Windows 95 Installation ............................................................. 8
Uninstall the Drivers ................................................................. 12
Windows NT 4.0 Installation .................................................... 13
Install Dial-Up Networking ................................................................. 13
Install Remote Access Service ............................................................. 16
Install Internet Explorer and ISDN Diagnostic Tool ........................ 17
Windows NT 3.51 Installation .................................................. 18
Windows NT 3.51 addendum..................................................... 20
FCC Compliance Statement ...................................................... 21
No part of this manual may be reproduced, transmitted, or stored in any media
form or by any means without the written permission of Tyan Computer
Corporation. Copyright (C) 1996-7 by Tyan Computer Corporation. All Rights
Reserved. The information in this manual is subject to change without notice.
V1.2
Netscalibur is a trademark of Tyan Computer Corporation.
Windows 95 and Windows NT are trademarks of Microsoft Corporation.
Pentium is a trademark of Intel Corporation.
Internet Explorer is a trademark of Microsoft Corporation.
Navigator is a trademark of Netscape Communications Corporation.
Any other trademarks are hereby acknowledged.

Advertisement

Table of Contents
loading

Related Manuals for TYAN NETSCALIBUR

Summary of Contents for TYAN NETSCALIBUR

  • Page 1 FCC Compliance Statement ............21 No part of this manual may be reproduced, transmitted, or stored in any media form or by any means without the written permission of Tyan Computer Corporation. Copyright (C) 1996-7 by Tyan Computer Corporation. All Rights Reserved.
  • Page 2 Windows 95 User Power off the system and insert the Netscalibur Card. Boot to Windows 95 and select "Do not install a driver (Windows will not prompt you again)." Insert the Netcalibur CD and click on the SETUP option. Install the modem drivers, ISDN acceleration pack, ISDN diagnostic tool, and Internet Explorer.
  • Page 3 LAN access, and telecommuting for individuals, small businesses, and corporate enterprises. ISDN and 33.6K modem connections can be used simultaneously. 1 Netscalibur Internet Accelerator Card 1 Installation Guide 1 Setup CD 1 RJ-45 to RJ-11 ISDN cable...
  • Page 4 Your system should have the following: Intel Pentium 75Mhz (120Mhz recommended) or Pentium Pro Windows 95 or Windows NT 4.0 or 3.51 Motherboard with at least 256K external cache 8MB of DRAM (16MB recommended) CD-ROM drive Sound Card (Wavetable recommended) (RJ-45 or RJ-11) (RJ-11) If the phone company installs a RJ-45 phone...

  • Page 5: On-Line Browser Manual

    Netscalibur also comes with an easy-to-use browser manual. The On-Line browser manual is an extension of the printed manual. You can launch the browser manual by double-clicking the Netscalibur icon and then selecting the Browser Manual. Make sure you install Internet Explorer or Navigator before launching the browser manual.
  • Page 6 For everyday usage, you will find the following information useful. L1,L2, and L3 lights turn grey color: This means that the Netscalibur card is not in your system. L1,L2, and L3 lights turn green color: This means that the ISDN is working properly and the driver has loaded successfully.

  • Page 7: Cable Connection

    L1, L2, and L3 lights turn red: This means that the driver is not loaded. For Windows 95 users, first check the Netscalibur's network properties in the Device Manager for resources conflicts. An interrupt or IO address conflict will prevent the driver from loading. You can access the...
  • Page 8 Power off the system and insert the Netscalibur into an empty 16-bit ISA slot and remove other modem cards from the system. Afterwards, power on the system and boot to Windows 95. You must install the ISDN accelerator pack v1.1 or above before installing Netscalibur's ISDN driver.
  • Page 9 4. Insert the Netscalibur CD into the CD-ROM drive. The Netscalibur Wizard should auto-start or you can double click on the Netscalibur CD-ROM icon to launch the Netscalibur Wizard. If your CD-ROM drive does not perform auto-run or double-clicking the Netscalibur icon does not bring up the Netscalibur Wizard, then you can run the setup program by selecting Open from the file menu.
  • Page 10 Part A Install Modem Drivers Part B Install ISDN Acceleration Pack and ISDN Diagnostic Tool Do not restart the system after Part B. During the setup procedure, please wait for Windows 95 to finish updating the shortcuts before going to the next step.
  • Page 11 Browse button to locate your CD-ROM drive and then find the ISDN driver under the \driver\isdn directory on the Netscalibur CD and click OK to continue. Then enter the switch type, ISDN phone numbers, and SPID numbers of your ISDN line. This information should be given by the phone company.

  • Page 12: Uninstall The Drivers

    Adapter folder. Next, click on the Remove button to remove the driver. Finally, restart the system. If you decide to take the Netscalibur out of your NT system, you must uninstall the drivers first. Otherwise, Windows NT may not boot.

  • Page 13: Install Dial-Up Networking

    Windows NT 3.51 user go to page 18 Windows NT 4.0 user start here A. Install Dial-up Networking Do not install Netscalibur's driver during Windows NT installation. Please complete the Windows NT installation first. In the Control Panel, double click on the network icon.
  • Page 14 Next, click on the Select from list button to continue. Insert the Netscalibur CD and click on the Have Disk button. Browse to the CD's \Driver\ISDN directory. Next, highlight Tyan Netscalibur ISDN Modem and click on the OK button to continue.
  • Page 15 Click Next to continue installing. From time to time, Windows NT will prompt you for the location of the Windows NT CD. Please type in the correct NT CD location. In this step, you have to select an available IRQ, address, and switch type.

  • Page 16: Install Remote Access Service

    Continue to install RAS (Remote Access Service) in the next step. B. Install Remote Access Service (RAS) Pick ISDN1-Netscalibur and click OK. Then click on the Add button to add the second B channel. Select ISDN2-Netscalibur and click OK. Then click on Network to configure the dial out protocol.
  • Page 17 Please refer to the next section if you are using Windows NT 3.51. You can double click on the Netscalibur icon and then select SETUP to install the Microsoft Internet Explorer and ISDN diagnostic tool. Notice that the setup options are different from Windows 95.

  • Page 18: Windows Nt 3.51 Installation

    When Windows NT 3.51 prompts you to install a network card, click on the NO button to skip. Then click on the Add Adapter button to add the Netscalibur. Next, select Requires disk from manufacturer and type in the \driver\isdn directory of the Netscalibur CD.
  • Page 19 Also, do not enter a "-" or "," between the numbers. space Pick ISDN1-Netscalibur and click OK. Then click on the Add button to add the second B channel. Select ISDN2-Netscalibur and click OK. Then click on Network to configure the dial out protocol.
  • Page 20 Netscalibur icon and then select SETUP to install Microsoft Internet Explorer 3.0 for Windows NT 3.51. After installing Internet Explorer, you may need to run it once before running the Netscalibur's browser manual. Notice that the setup options are different from Windows 95.
  • Page 21 (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Model: Netscalibur (N1732D) Type of Product: Internal Data/Fax/Voice PC card Manufacturer: Tyan Computer Corporation 1753 South Main Street Milpitas, CA 95035 U.S.A.

Table of Contents