Product Identification; Local Codes; Unpacking; Product Features - Desa Comfort Glow CG2618PV Owner's Operation And Installation Manual

PRODUCT
IDENTIFICATION

LOCAL CODES

UNPACKING

PRODUCT
FEATURES
4
Front Log
Front
Burner
Left
Branch
Piezo
Ignitor
Control Knob
Figure 1 - Vent-Free Gas Log Heater
Install and use heater with care. Follow all local codes. In the absence of local
codes, use the latest edition of The National Fuel Gas Code ANSI Z223, also
known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
National Fire Protection Association, Inc.
Note: Where listed vented decorative logs are required, thermostat operation is
not permitted.
1. Remove logs and heater base assembly from carton.
base assembly by burners. This could damage heater. Always handle base
assembly by grate.
2. Remove all protective packaging applied to logs and heater for shipment.
3. Check all items for any shipping damage. If damaged, promptly inform dealer
where you bought heater.
Operation
This heater is clean burning. It requires no outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by both realistic flames and glowing coals. This
heater is designed for vent-free operation with flue damper closed. State and local
codes in some areas prohibit the use of vent-free heaters. You can operate heater as a
vented product by opening flue damper.
Safety Device
This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shuts
off the heater if there is not enough fresh air.
Piezo Ignition System
This heater has a piezo ignitor. This system requires no matches, batteries, or other
sources to light heater.
1430 Broadway
New York, NY 10018
Batterymarch Park
Quincy, MA 02269
Rear Log
Rear
Burner
Right
Branch
Base Assembly
Note: Do not pick up heater
101992