Comfort Glow CCL3018NR Owner's Operation And Installation Manual page 16

INSTALLATION
Continued
4. Install remote receiver unit onto gas log heater
base using phillips head screws (see Figure 19).
5. Connect wires as shown in Figure 20.
Front
Screws
Remote
Receiver
Figure 19 - Installing Remote Receiver
White Wire From
Receiver
Red Wire
From
Receiver
Figure 20 - Connecting Wires
INSTALLING WIRELESS HAND-
HELD REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included) are
required to operate this heater with the wireless
hand-held remote control set. One battery must
be installed in the receiver and one in the hand-
held remote control unit. Note: Only use alkaline
batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of
heater.
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
16
Receiver
9-Volt
Battery
Figure 21 - Installing Receiver on the
Back
Installing 9-Volt Battery (Not Included) in
Hand-Held Remote Control Unit
1. Remove battery cover on back of remote con-
trol unit.
2. Attach terminal wires to the battery. Place
battery into the battery housing.
3. Replace battery cover onto remote control
unit.
Terminal
Wires
Valve
9-Volt
Battery
Figure 22 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCB
Remote Control Unit
Figure 23 - Installing Battery in Hand-
Held Remote Control Unit (CGHRCTB
www.desatech.com
Battery
Clip
Back of the Base
Battery
Housing
Series)
Series)
Terminal
Wires
Battery
Cover
Remote
Control
Unit
111161-01D