Table of Contents
Advertisement
INSTALLATION
Continued
Assembling Brass Trim (Brass
trim shipped with mantel)
1. Remove packaging from three remain-
ing pieces of brass trim.
2. Locate two adjusting plates with set
screws, and two shims in the hard-
ware packet.
3. Align shim under adjusting plate as
shown in Figure 14.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top brass trim
(see Figure 14).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side brass
trim (see Figure 14).
6. While firmly holding edges of brass
trim together, tighten both set screws
on the adjusting plate with slotted
screwdriver.
7.
Repeat steps 1 through 6 for other corner.
8. Set brass assembly aside for later in-
stallation.
Top Brass Trim
Set
Slot
Screws
Shim
Adjusting
Plate
Slot
Figure 14 - Assembling Brass Trim
104407
INSTALLING BLOWER
ACCESSORY GA3400T
Removing Upper Louver
Assembly
To install the blower accessory, you must
first remove the upper louver assembly.
1.
Lift screen off heater.
2.
Remove 4 screws from louver assem-
bly (see Figure 15). Save these screws.
3.
Pull louver assembly straight out from
the cabinet. Be careful not to scratch
the paint. Set louver assembly and
screws aside.
Figure 15 - Removing Upper Louver As-
sembly
Mitered Edge
Removing Valve Cover Shield
Side Brass
1.
Open bottom louver assembly by
Trim
swinging the assembly down (see Fig-
ure 16).
2.
Using short Phillips screwdriver, re-
move the screw under the center of the
branch support. Rotate valve cover
shield clockwise and slide out.
IMPORTANT: Do not remove shoul-
der screw on the left side of valve cover
shield. Slide the valve cover shield off
of the shoulder screw (see Figure 16).
Note: If you do not have a short
Phillips screwdriver, the screen, twigs,
and branch support must be removed
so a longer screwdriver may be used.
See Connecting Fireplace To Gas Sup-
ply, page 15 and follow step 2.
OWNER'S MANUAL
Blower Bracket
Mounting Holes
Upper Louver
Assembly
Brass Screws
11
Branch
Support
Shoulder
Screw
Remove
Screw
Valve
Cover
Shield
2
1
Snap
Bushings
Figure 16 - Removing Valve Cover Shield
Installing Blower Assembly
Note: If you are using a mantel with your
heater, use the following instructions. If
your heater is built-in, see For Built-In In-
stallation on page 13.
1.
Install snap bushings found in hardware
kit into both holes in rear of valve cover
shield.
2.
Make sure the wire harness is firmly
connected to the terminals on the blower
bracket assembly.
3.
Note the wire locations on back of
AUTO/OFF/ON switch. The terminals
on back of switch are numbered 1, 2,
and 3. Carefully remove red wire from
terminal 1 and blue wire from terminal
3. Black wire can remain on middle
terminal 2 (see Figure 17, page 12).
Bottom Louver
Assembly
Continued
Advertisement
Table of Contents
