Cleaning And Maintenance - Desa VC42NE SERIES Owner's Operation And Installation Manual

CLEANING AND
MAINTENANCE
WARNING: Turn off fireplace
and let cool before cleaning.
CAUTION: You must keep con-
trol areas, burners and circulating
air passageways of fireplace clean.
Inspect these areas of fireplace
before each use. Have fireplace
inspected yearly by a qualified
service person. Fireplace may
need more frequent cleaning due
to excessive lint from carpeting,
bedding material, pet hair, etc.
GLASS DOOR
WARNING: Handle glass door
panel with care. Do not strike, slam
or otherwise abuse glass. Do not
operate fireplace with the glass
door unlatched, removed, cracked
or broken.
WARNING: Do not use abra-
sive cleaners as this may damage
glass. Use a nonabrasive house-
hold glass cleaner to clean glass.
Do not clean glass when hot.
Glass must be cleaned periodically. During start-up
it is normal for condensation to form on the inside
of the glass causing lint, dust and other airborne
particles to cling to the glass surface. During initial
start-up a slight film may form on the glass due to
paint curing. The glass should be cleaned several
times with a non-ammonia, nonabrasive household
cleaner and warm water after the first two weeks of
operation. Thereafter, clean the glass two or three
times during each heating season, depending on the
usage and circumstances present. Refer to Remov-
ing/Replacing Glass Door, page 24 of this manual
when removing glass door for cleaning.
30
plied by the manufacturer should
be used when replacing broken
or damaged glass door panel
(see Replacement Parts, page
34). This glass door panel is
a complete unit. No substitute
materials may be used.
safety glasses while handling or
removing broken glass. Do not re-
move if glass is hot. Keep children
and pets away from glass.
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
24). Vacuum all glass pieces with a shop vac.
CAUTION: Do not vacuum if
pieces are hot.
Use only the tempered glass door replacement
intended for this fireplace (see Replacement Parts,
page 34 for detail on ordering). No substitutions
may be made. See Removing/Replacing Glass Door,
page 24 for instructions for replacing glass door.
WARNING: Do not operate fire-
place with the glass door unlatched,
removed, cracked or broken.
PILOT AND BURNERS
• Remove ember material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
LOGS
• If you remove logs for cleaning, refer to Install-
ing Lava Rock and Glowing Embers, page 25,
to properly replace logs.
• Use a vacuum cleaner to remove any carbon
buildup on logs.
• Replace log(s) if broken. See Replacement
Parts on page 34.
• Replace ember material periodically as needed.
See Replacement Parts on page 34.
www.desatech.com
WARNING: Only parts sup-
CAUTION: Wear gloves and
116237-01E