Table of Contents
Advertisement
PRODUCT
IDENTIFICATION
Control
Knobs
Piezo
Ignitor
Remote Selector
Switch (Optional)
Figure 1 - Log Base Assembly
Top Louvered
Hood
Firebox
Support
Screen
Assembly
Figure 2 - Fireplace
107063
Log Set
Optional Remote
Control
Top Outer
Casing
Bottom Louver
Assembly
3
OWNER'S MANUAL
LOCAL CODES
Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1.
With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing. Note: The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
2. Locate two screws above top corners
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
3. Remove protective packaging applied
to logs, log base assembly, and fire-
place.
4. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought fireplace.
REMOTE CONTROL
ACCESSORIES
The remote controls that can be purchased
separately for this log heater are hand held
remotes. See Accessories, pages 24 and 25.
Rear
Access
Door
1430 Broadway
Advertisement
Table of Contents
