Desa CDCFNR Owner's Operation And Installation Manual page 21

INSTALLATION
Continued
IMPORTANT: The wire may be shortened but
must not be lengthened.
4. Connect one bare wire end to each of the
terminals of the provided wall switch.
5. Install the wall switch and cover in the wall.
INSTALLING LOG SET AND SCREEN
(Models with One-Piece Screen Only)
1. Remove log packaging material and discard
packaging. Gently place log over burner (see
Figure 35). Do not allow log to contact flame.
If flame contacts log, soot will be created.
2. Reattach screen by placing the notches in the
screen frame over the shoulder screws and
pushing down.
Shoulder
Screw
Log
Figure 35 - Installing Log and Screen
INSTALLING BRICK LINERS AND
LOG SET AND SCREEN
(Models CDCFNR and CDCFPR Only)
1. Remove packaging from brick liners previ-
ously removed from behind top louver.
2. Place rear brick liner against back of firebox.
The left and right brick liners will hold this
liner in place (see Figure 36). Be sure to hold
the rear brick liner while installing the sides
so it will not fall forward.
3. Install left and right brick liners using brackets
and screws from hardware kit as shown in Fig-
ure 37. Screw the bracket into top of firebox
and against brick liners. Adjust bracket before
tightening screw.
4. Remove log packaging material and discard.
Gently place log over burner (see Figure 38).
(Do not allow log to contact flame as this will
create sooting.)
5. Insert each rod through ten rings located at
top of screen (see Figure 39, see page 22).
111244-01D
Screen
www.desatech.com
Figure 36 - Installing Rear Brick Liner
Brick Liner
Bracket and
Screw
Left Brick
Liner
Figure 37 - Installing Side Brick Liners
Figure 38 - Installing Log
21