ACRONIS TRUE IMAGE ECHO - ENTERPRISE SERVER User Manual page 151

letter]
/harddisk:[disk number]
/partition:[partition
number]
/target_harddisk:[disk
number]
/target_partition:[partiti
on number]
/start:[start sector]
/size:[partition size in
sectors]
/fat16_32
/type:[active | primary |
logical]
151
number). This option is used with
case the file name must be specified without drive letter or root
folder. For example:
/file_partition:D /filename:"\1.tib"
Dynamic volumes are specified with prefix DYN, e.g.:
/file_partition:DYN1 /filename:"\1.tib"
Specifies the basic hard disks to restore.
Specifies the partitions to restore.
Dynamic volumes are specified with prefix DYN, e.g.:
/partition:DYN1
Specifies the hard disk number where the image will be restored.
By specifying
/target_harddisk:DYN
you will select unallocated space on all dynamic disks that present
in the system.
Specifies the target partition number for restoring a partition over
the existing one. If the option is not specified, the program assumes
that the target partition number is the same as the partition number
specified with the
/partition
Dynamic volumes are specified with prefix DYN, e.g.:
/target_partition:DYN1
Sets the start sector for restoring a partition to the hard disk
unallocated space.
Sets the new partition size (in sectors).
Enables the file system conversion from FAT16 to FAT32 if the
partition size after recovery is likely to exceed 2GB. Without this
option, the recovered partition will inherit the file system from the
image.
Sets the restored partition active, primary or logical, if possible (for
example, there cannot be more than four primary partitions on the
disk.) Setting a partition active always sets it primary, while a
partition set primary may stay inactive.
If the type is not specified, the program tries to keep the target
partition type. If the target partition is active, the restored partition
is set active. If the target partition is primary, and there are other
primary partitions on the disk, one of them will be set active, while
the restored partition becomes primary. If no other primary
partitions remain on the disk, the restored partition is set active.
When restoring a partition on unallocated space, the program
extracts the partition type from the image. For the primary
partition, the type will be set as follows:
- if the target disk is the 1st according to BIOS and it has not other
primary partitions, the restored partition will be set active
- if the target disk is the 1st according to BIOS and there are other
primary partitions on it, the restored partition will be set logical
- if the target disk is not the 1st, the restored partition will be set
logical.
/filename:file_name
option.
Copyright © Acronis, Inc., 2000-2009
. In this