3 Remove the hard drives from:
–
slots 0 to 2 in PowerVault MD3200
slots 0 to 5 in PowerVault MD3220
–
See "Removing a Hard Drive" on page 192.
NOTE:
4 Slide the control panel out of the chassis after:
–
Pushing the release tab toward the front of the array in PowerVault
MD3200. See Figure 15-13.
–
Pulling the release pin toward the front of the array in PowerVault
MD3220. See Figure 15-14.
Figure 15-13. Removing and Installing the Control Panel—PowerVault MD3200
1
1
control panel
Mark each hard drive with it's slot position as you remove it.
Management: Installing Array Components
2
2
release tab
207