Table of Contents
Advertisement
Important notes
Additional safety notes for devices with radio components
●
Switch off the radio components (the ON/OFF switch must be in the "OFF" position) when you
are at an airport or driving in a car.
●
Switch off the radio components (the ON/OFF switch must be in the "OFF" position) when you
are in a hospital, an operating room or near a medical electronics system. The transmitted
radio waves can impair the operation of medical devices.
●
Switch off the radio components (the ON/OFF switch must be in the "OFF" position), when you
take the device close to flammable gases or into hazardous environments (e.g. petrol station,
paintshops), as the transmitted radio waves can cause an explosion or a fire.
●
The range of the radio connection is dependent on environmental and ambient conditions.
●
With data traffic via a wireless connection, it is also possible for unauthorised third parties to
receive data.
Fujitsu Technology Solutions GmbH cannot be held responsible for radio or television faults arising
from unauthorised modifications made to this device. Fujitsu Technology Solutions GmbH is,
furthermore, not responsible for replacing and / or exchanging connector cables and devices which
have not been specified by Fujitsu Technology Solutions GmbH. The user bears sole responsibility
for repairing faults arising from such unauthorised modifications made to a device and for replacing
and/or exchanging devices.
Notes on installing and removing boards and components
Only qualified technicians should repair the device. Unqualified users who open the
!
notebook's case expose themselves to electric shock and fire hazards.
Boards with electrostatic sensitive devices (ESD) are marked with the label shown.
When handling boards fitted with ESDs, you must always observe the following points:
●
You must statically discharge yourself before working on the boards (e.g. by touching an
earthed object).
●
The equipment and tools you use must be free of static charges.
●
Pull out the power connector and remove the battery before you install or remove boards.
●
Always hold boards with ESDs by their edges.
●
Never touch pins or conductors on boards fitted with ESDs.
4
A26391-K279-Z220-1-7619, edition 1
Advertisement
Table of Contents
