To update the system firmware, the Compaq System ROMPaq
NOTE: This utility is not to be confused with the Options ROMPaq utility (refer to Chapter 5),
which is used to update the firmware on server options and SCSI drives.
This utility has two main sources:
•
The Compaq SmartStart
directly from Compaq
•
The downloadable Compaq SoftPaq
If your server has a bootable CD-ROM drive, you can run System ROMPaq directly
from the CD. Otherwise, you must run System ROMPaq from a diskette created from
either the CD or from the SoftPaq file.
IMPORTANT: Compare the version numbers of the System ROMPaq utility from these two
sources. If the CD version is older, use the SoftPaq file instead.
Running System ROMPaq from the CD
1. Boot the server from the SmartStart CD.
2. On the Compaq System Utilities screen, select Run ROMPaq.
3. Follow the on-screen prompts and instructions to reprogram your system ROM.
Compaq Smart Array 5300 Controller User Guide
Updating the System Firmware
TM
CD that is either shipped with your server or available
TM
file on the Compaq website
4
TM
utility is used.
4-1