Installing The Smart Array Controller - Compaq 166207-B21 - Smart Array 5302/32 RAID Controller User Manual

Installing the Hardware
4. Unplug the AC power cord from the outlet, and then from the server.
IMPORTANT: If you will be replacing a Smart controller with a Smart Array controller, see
the "External Cabling for Compaq Servers" section to determine the external cabling
requirements.
5. Disconnect any peripheral devices from the server.

Installing the Smart Array Controller

1. Remove or open the access panel.
2. Select an available 66-MHz PCI slot. Slots that use a 64-bit interface may
provide higher performance.
3. Remove the slot cover or open the hot-plug latch. Save the retaining screw, if one
is present.
4. Slide the controller board along the slot alignment guide.
3-2
WARNING: To reduce the risk of personal injury from hot surfaces, allow
the internal system components and hot-plug hard drives to cool before
touching them.
CAUTION: Electrostatic discharge (ESD) can damage electronic components.
Be sure that you are properly grounded before continuing the installation
procedure. See Appendix B for ESD information.
Compaq Smart Array 5300 Controller User Guide