Sonos ZonePlayer100 Product Manual page 6

4
Mute button (green)
ZonePlayer Status
Indicator (white)
Connect First ZonePlayer 100
Important: The first Sonos component you install must connect to your home
network using a standard Ethernet cable (supplied). If you prefer to use this
ZonePlayer wirelessly, you can connect a SONOS BRIDGE to your router instead.
Connect a standard Ethernet cable (supplied) from any of the four (4) Ethernet switch connectors on the back of your
ZonePlayer to an open port on your router (see A in the diagram below). Do not connect the ZonePlayer directly to your cable
or DSL modem unless your modem has a built-in router.
• If you don't have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don't have an open port on your router, you can disconnect your computer from the router and connect it to the
ZonePlayer instead. Then connect the ZonePlayer into the router port the computer was previously plugged into.
Proceed to step 2 when the Status indicator on the ZonePlayer's
front panel flashes white and the Mute button flashes green.
User Guide