Table of Contents
Advertisement
Sonos ZonePlayer 100
ZP100 Rear Panel Connectors
Ethernet switch connectors (4)
Right speaker terminals
Left speaker terminals
Voltage select
AC power (mains) input
Analog audio out (fixed/variable)
Analog audio in
Subwoofer output
Note: If you disconnect your subwoofer, make sure to
also disconnect the subwoofer's cable from the
ZonePlayer output.
Use Category 5 Ethernet cable to connect to a router, computer, or additional network
device such as a network-attached storage (NAS) device.
LED indicators:
•
Green (link connection)
•
Flashing Yellow (network activity)
Use high-quality speaker wire to connect the right speaker to the ZonePlayer.
Use high-quality speaker wire to connect the left speaker to the ZonePlayer.
115V/230V
Select the appropriate voltage setting for your country.
Use the supplied power cord to connect to power outlet.
You may use a standard RCA audio cable to connect the audio inputs on a separate audio
component such as an amplifier or your home theater receiver, to the ZonePlayer's
analog audio outputs.
You may use a standard RCA audio cable to connect the ZonePlayer's analog audio inputs
to the audio outputs from a separate audio component, such as a CD player or a portable
music player.
You may connect a powered subwoofer to this output using a standard RCA cable. The
system will detect when a cable is connected to the subwoofer output and adjust the
crossover frequency automatically.
11
Advertisement
Table of Contents
