Installation - Desa H) Owner's Operation And Installation Manual

10
OPTIONAL WIRELESS HAND-HELD REMOTE
CONTROL INSTALLATION
Note: If using optional wireless hand-held remote control, the wall
switch is no longer operational.
Installing Receiver
1. Remove the front refractory access panel by lifting up and angling
out of the firebox opening (see Figure 13) to expose controls.
2. Disconnect wall switch wires from TH and TH/TP terminals
on control valve (see Figure 14).
3. Install remote receiver unit onto mounting bracket using the
two plastic mounting clips (see Figure 15).
For more information, visit www.desatech.com
Note: If any of the original wire as supplied must be replaced, use 18 AWG
TYPE CL2 (UL) 105 C (25 ft. length MAXIMUM) or equivalent.
Figure 14 - Wall Switch Wiring Diagram
Receiver
Plastic
Mounting
Clips
Mounting Bracket
Figure 15 - Installing Remote
Receiver (Shown from Rear of
Mounting Bracket)
108795-01M