Table of Contents
Advertisement
ST2-XM TUNER PROGRAMMING
ST2 TUNER SETUP MENU
ST2-XM Tuner Setup Menus
Note: The Setup Menu procedures must be performed from the ST2-XM Tuner front panel.
The ST2-XM Tuner Setup Menus provide setup and naming procedures for the ST2-XM main chassis,
the XM tuner module and the AM/FM tuner module. These procedures include source number assign-
ments, assigning a custom name to a memory preset or a bank, choosing a region for AM/FM opera-
tion (US or Euro), factory initialization and system information.
If the ST2-XM is used with a non-RNET system, the ST2-XM can be connected and operated without
any setup programming. Follow the setup menus if custom names are desired, or for system info.
If the ST2-XM is used with an RNET system such as CAV6.6, the following minimum setup must be
performed for the ST2-XM to be properly controlled by the CAV6.6:
1. ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2. RNET Controller Source Setup Menu - Configure the source numbers assigned in step 1 for Tuners
1 and 2, and assign command type PERIPHERAL.
NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to
the RNET controller (must be powered on last) to establish a connection.
ST2 Chassis Setup Menu
Source Number (Chassis)
The Source Number procedure permits Tuner 1
(XM) and Tuner 2 (AM/FM) to be assigned the
proper source numbers to be used in an RNET
system.
Note: The source number must be assigned as
PERIPHERAL in the RNET controllers.
Note: Each of the ST2-XM modules can be con-
figured as source number "unassigned" if the
module is used in another system (e.g., home
theater) or will not be used as a source in the
RNET system.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until SOURCE NUM appears on the tuner.
3. Press BAND. TUNER # appears.
4. Press the Tune Up/Down buttons to select the
Tuner # (Tuner 1 is XM, Tuner 2 is AM/FM).
5. Press BAND. SOURCE NUM appears.
6. Press the Tune Up/Down buttons to scroll
26
through the source numbers 1-6.
7. Press BAND to select the source number.
8. Repeat the process for the next tuner.
9. Press TNR SEL to exit the Source Number
menu.
Update Firmware (Chassis)
The Update Firmware procedure allows the ST2
tuner's OS firmware to be updated. The proce-
dure is performed using a DB9 serial cable with
one end connected to the RS-232 port on the
back of the tuner and the other connected to a
PC or laptop. If an OS firmware update is avail-
able, it can be obtained through the Document
Center at www.russound.com . XM tuner module
firmware update must be performed by an
authorized Russound service facility.
1. Enter the Setup Menu by pressing and holding
the TNR SEL button.
2. TUNER SETUP appears. Press MEM Up/Down
until UPDATE FIRMW appears on the tuner.
3. Press BAND to enter the UPDATE FIRMW menu.
4. "Hold BAND" appears on the tuner.
Advertisement
Table of Contents
