Dell DX6004S Hardware Owner's Manual page 41

Table 1-2. System Messages
Message
No boot sector on
hard drive.
No timer tick
interrupt.
PCIe Training
Error: Expected
Link Width is x,
Actual Link Width
is y.
Plug & Play
Configuration
Error.
Quad rank DIMM
detected after
single rank or
dual rank DIMM in
socket.
(continued)
Causes
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive.
Faulty system board.
Faulty or improperly
installed PCIe card in the
specified slot.
Error encountered in
initializing PCIe device;
faulty system board.
Invalid memory
configuration.
Corrective Actions
Check the hard drive
configuration settings in the
System Setup program.
See "Using the System Setup
Program and UEFI Boot
Manager" on page 51.
If necessary, install the
operating system on your
hard drive. See your
operating system
documentation.
See "Getting Help" on
page 161.
Reseat the PCIe card in the
specified slot number.
See "Troubleshooting an
Expansion Card" on
page 149. If the problem
persists, see "Getting Help"
on page 161.
Install the NVRAM_CLR
jumper in the clear position
(pins 1 and 3) and reboot the
system. See Figure 6-1 for
jumper location. If the
problem persists,
see "Troubleshooting an
Expansion Card" on
page 149.
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 98.
About Your System
41